Trace the handle you plan to buy

Lay the sample on paper and mark the ends, the fixing centres and the outline of its feet. Label the top of the sheet. A long pull can have fixings surprisingly far in from the ends. If you mark only the overall length, the template tells the installer little about where the holes belong.

Look and reach from your usual position

Tape the paper to the drawer face with a finish-safe method approved for the surface, or use a scrap board held in front of it. Try a centred position and one closer to the upper edge. Stand back, then approach from the side where you normally cook. Hold the actual pull against a scrap of similar thickness and check the space behind it with your fingers.

Open the neighbouring front

At an inside corner, a projection that looks modest in elevation may catch the handle on the next unit. Move both doors through their normal arcs with someone holding the samples. Mark the approved fixing centres from one named edge on a dimensioned drawing. Keep the drilling template and drawing together until all the fronts are fitted.

The diagram shows where to measure the centre-to-centre spacing of a pull and how to transfer the fixing positions to the door. [1]