A timber board and a piece of tile can sit flush on the kitchen table and still land at different heights in a doorway. Under each finish is another set of layers. Before the order goes in, ask the people fitting both floors to draw that joint together.
Start at the finished surface
Sketch a section looking across the threshold. Ask each installer to label the finish and every supporting layer included in their proposal. On one side there may be an underlay. On the other there may be an adhesive bed and a preparation layer. Mark a height that both installers can refer to on site, then compare the proposed finished levels against it.
Put the door in the drawing
Mark the position of the closed door on the section. Look at the proposed joint from both sides. If you want the change of material to disappear with the door shut, check it against the actual leaf and frame. Look at the swing as well, including the mat that usually lives there.
Agree on a profile before fitting
Ask which transition detail suits the selected flooring system and its movement requirements. A drawing for one floating floor does not establish the gap for another product. Put a real sample of the proposed trim between the finishes, then view it from standing height. Record its finish and who supplies it while there is still time to change the order.
Give one person responsibility for confirming the joint with both installers. A signed-off sketch is more useful at fitting time than two separate samples.
The diagrams distinguish a joint between floors of equal height from one that needs an adapter for a change in level. [1]
